FROM TÜRKİYE. CONNECTING THE WORLD.
Contact

BEMİS GLOBAL

Motor turning the wrong way? Phase sequence and phase-reversing plugs

Short answer: A three-phase motor turns in the direction set by the phase sequence (L1–L2–L3). If a site is wired in a different sequence, the motor runs backwards; swapping any two phases reverses it. A phase-reversing plug or inlet lets you swap two phases at the connector with a screwdriver, without rewiring the cable. Disconnect it first and check the sequence with a phase-rotation tester. Bemis makes 5-pin (3P+N+E) phase-reversing plugs and inlets for 16 A and 32 A, IP44 and IP67.

Bemis productRated currentContactsProtectionProducts
Straight plug, phase reversing16 A, 32 A3P+N+EIP44, IP674
Rotating plug 90°, phase reversing16 A, 32 A3P+N+EIP442
Appliance inlet, phase reversing16 A, 32 A3P+N+EIP44, IP674
Wall inlet 90°, phase reversing16 A, 32 A3P+N+EIP44, IP676

Frequently asked questions

Why does the same machine run correctly on one site and backwards on another?

Sites are not always wired with the same phase sequence. The connector fits either way, so the direction of rotation depends on the installation.

Is it safe to swap phases in the plug?

Only with the plug disconnected from the supply. A phase-reversing plug is made for this: the cable stays in its terminals and only the contact positions change.

Does phase sequence matter for single-phase equipment?

No. It only affects three-phase motors and other equipment that depends on the direction of rotation, such as pumps, fans and compressors.

Glossary → · International sales →

BEMIS GLOBAL PARTNERS

Local expertise. Global ambition.

Bring Bemis to your market. Let’s talk about building a distribution partnership in your country.

Become a distributor ↗